
Voice Module W-
The 4285 is
wired betweenthe controlpanel end the premiseshandset(s). It
listens for touch tones on the phone line and reports them to the control
panel. During on-premises phone access,it powers the premises phones;
during off-premisesphone access,it seizesthe line Ikomthe premisesphones
and any answeringmachines.
Note: The phone lines must be in servicefor the voicemodule to fi.mction,
evenwhen accessingthe systemborn an on-premisesphone.
1. Make 12V (+) and (–) and data in and data out connectionsfkomthe Voice
Module to the control,using the connectorcablesupplied with the Voice
Module (seeFigure 16). -
ColorLead
TerminalOn Control* *
GREEN
DATAIN (terminal6)
>
BLACK
I
AUX- (teminal 4)
J
IRED
I AUX+[termina15) I
--
These are
the same
connections as those
usedfor remoteke~ads
connectedto Partition1.
YELLOW
I
DATAOUT (terminal7)
2. Insertthe keyedconnectorat the other end of the connectorcableinto the
mating header on the VoiceModde (seediagram on next page for location
of the header).
3. Connect terminals 1 through 5 on the Voice Module as shown in the
Wiring Table belowand in the 4285 wiring diagram that follows.
428!5WIRLNG TABLE
4265
Terminal
COnneots*.
1.
PhoneIn (Tip)
Terminal(21)oncontrol.
2. PhoneIn (Ring)
Terminal(22)oncontrol.
I S. PhoneOut (TiD) I BROWNleadflom direckonnectcord.I
4. PhoneOut (Ring) GRAYleadborndirect<onnectcord.
5. Ground Earthgroundterminal(25)oncontrol.
6.
Not Used
7.Not Used
Caner munits
If the telephonesystemon the premisesincludes a Caller ID unit, connectthe
unit directly to the %andsetm temrinals (21 & 22) On tie con~ol~ as
shownin 4285VoiceModule Wiring Connectionsdiagram that follows.
-!51-
Comentarios a estos manuales