Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 45)

~~g OptiOnS Defined

The following will help you understand the programming of OUTPUT

DEVICES when using *8O and *81 modes. The options used to start and

stopthesedevicesare describedbelow,followedby the actual screenprompts

and availableentries.

The letter(s)in parenthesesafter each function describedbelow, such as (A)

tier ACTION, are those that appear in the various summary displays of

programmeddata during programming.

ACTION (A) The “ACTION”of the deviceis how the devicewill respond

when it is activated by the “START programming. You

may want the deviceto activate momentarily, to pulse on

and off continuously, or to remain activated until some

other event occurs to stop it. There are four different

choicesof actions:

. ACTIVATE for 2 SECONDS and then reset.

c ACTIVATE and REMAIN ACTIVATED until stoppedby

someother event.

. PULSE ON and OFF until stoppedby someother event.

Q NOT USED when the deviceis not used.

START (S27’) The “START” programming determines when and under

what conditionsthe devicewill be activated. The following

START optionsare available:

A) 1. EVENT (EV) is the condition (Alarm, Fault, Trouble) that

must occurto a zone or group of zones(zone list) in order to

activate the device. These conditions apply

only when a

zone list is used. The different choicesfor “EVENT” are

listed below and in the “Programming Output Relays &

PowerlineCarrier devices”sectionthat follows.

Q ALARM

Relay action begins upon any alarm in

an assignedzone in the zonelist.

. FAULT

Relay actionbegins upon any opening or

short in an assigned zone in the zone

list.

● TROUBLE

Relay action begins upon any trouble

conditionin an assignedzonein the zone

list.

. NOT USED Relay action is not dependent upon one

of the aboveevents.

2. ZONE LIST (ZL) is a group of zones to which the

“EVENT” applies in order to activate a particular device.

Note that there are a total of 3 zone lists that can be

programmed in field *81 mode; when the selectedEVENT

(Alarm, Fault or Trouble) occurs in any zone in the

selected“Start” ZONE LIST (1, 2, or 3), activation of the

selecteddevicewill START.

B) 1. ZONE TYPWSYSTEM OPERATION (ZT). If a System

Operation, such as

“DISARMING” or “ANY FIRE

AIARM,” is to activate the device,the appropriate choice

would also be entered under the “ZONE TYPE” option.

“ZONE TYPE” is used independently of the

“EVENWZONE LIST” combination.

If a specific“ZONE TYPE”

is chosen, any zone of that re-

sponsetype going into alarm, trouble, or fault will causethe

device to activate as selectedin “ACTION.” If the same

“ZONE TYPE” is also chosenfor the STOP programming,

any zone of that type that restores will de-activate the

device.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 119 120

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 45

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE