Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 38)

TRANSMIT NOW

If “yes” is selected’in response to the “Learn

MN?” prompt, this display will appear.

Fault and restore the transmitter to be learned.

A simzlebee~ will be heard at the kevoad. Wait

68 s~conds.’~aultand restorethe tr=mitter a

secondtime. ‘IWObeepswill be heard, indicating

acceptanceinto the system.

Note If a long beep occurs,it means that the

particular transmitter input has

previously been registered in the

system.

Mark the zone number on the transmitter. If the

transmitter is a multi-button @pe, each of the

buttons used must assignedto a different zone,

and eachof the buttons must be learned.

Typicalsummary

display

AccsptedInput(Loop)Number

Program Alpha?

=Nol= Yes O

Enter Zn Num.

(00 = Quit)

After a transmitter has been learned, a

summary of the programmed values for the

selectedzone will be displayed.

If all is okay, press [*].

Alpha descriptorsfor the zones can be done now

(enter 1) or maybe done at a later time using

*82 interactive mode (enter O). We recommend

that the entry of Alpha descriptors be done

using *82 mode.

Refer to

Section 15. ALPHA DESCRIPTION

PROGRAMM~G

for specificprocedure.

If you entered ‘O* (no) in response to the

Program

Alpha ? prompt, the system will

display a prompt for entry of the number for the

next wirelessexpansionzone to be programmed.

Proceedwith the progr

smming of the next zone,

as indicated previously.

5. Exit the programming

g modeby keying $H19.

6. Use the transmitter Sniffer mode to test that all transmitters have all

been programmedproperly, as indicated next.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 119 120

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE