Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 20)

This sectionprovides information on how progr

amming is performed in this

system. It will enable you to understand how to enter and exit the

programming mode,and how to program the data fields and the user-friendly

interactivemodes (*56, *80, *81, *82, *83). We therefore urge you to read

and understand the followingbeforeproceedingwith the installation.

Rqmmmmg Infcmnation

Characteristicsfor eachinstallation are storedin non-removable, electrically

erasable,non-volatile EEROM memory. These must be programmed for the

particularinstallation to establishits specificalarm and

reporting features.

It is possible to program the system at any time, even at the installer’s

premisesprior to the actual installation. Simply appIy power temporarily to

the contioland then program the unit as desired.

Important Note: You cannot enter the programming mode unless

~ ptilioIM are disarmed.

There are two programming

g modes: data field pro-

amming and interactive

(menu) mode programming. Data field programming is used for setting

various system options and interactive programming is used for

progr

amming zoneinformation, progmmming

relay outputs, and for learning

transmitter serial numbers.

Rogramming

canalsobe performedremotely horn the installer’s office/home,

using an IBM personal computer, a modem, and V-Link downloading

software. See the

REMOTE PROGRAMMING AND CONTROL

(DOWNLOADING)

SeCtiOIl,

Entering Program Mode

You may use one of the followingmethods:

a) Press both the [*] and [#] keys at the same time within 50 seconds

after power is applied to the Control, or

b) Mter powerup, enter the Installer code(4 1 1 2)+ S O 0.

This method is disabledif you exit the program mode using *98 instead of

*99. See“Ex~ fiogram Mode” paragraph later in this section.

If a difTerentInstsler codeis subsequentlyprogrammed, use it instead of

4112to gain accessto the I?rogrammin

g mode.

Following entry into program mode, data field *2O will be displayed (this is

the first field in the system).The systemwill now acceptentries for field =0.

-~s a D* ~~d

1. Press [*] plus Field No. (for example,*21), then make the required entry.

2. When you have completely programmed a data field, the keypad will

“beep”three times and then automatically display the next data field in

sequence.Togo to a different field, press [*] PIUSthe desiredfield No.

-20-

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 119 120

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 20

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE