Vista Ademco -10SE Guía para resolver problemas Pagina 50

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 120
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 49
This section provides instructions for mounting the 4285 Voice Module,
wiring the VoiceModule and for programming the system for phone access
via the VoiceModule.
Inetal/jointfilesconvert/304319/bg the Voice Module
MomBation
The 4285 VoiceModule is an add-on accessoryfor the VISTA-20 that permits
accessto the security system via a Touch-tone phone (either on premises or
by a call-in when away).
The Voice Module can announce many of the same words that would
normaUy be displayedon an Alpha keypad under the samesystemconditions.
When properly connected,the 4285 Voice Module will enable the user to do
the followingvia a Touch-tonetelephone
a. Receivesynthesizedvoicemessagesover the phone regardiug the statueof
the securitysystem.
b. Arm and disarm the securi~ system and perform most other commands
using the telephonekeypad, with voiceannunciation being provided over
the phone as confirmationafter any commandis entered.
The phone used for phone accessmust have Touch-tone capabili@, though
Touch-tone service is not necessary (if premises uses PULSE dialing,
switchablephonesmust be set for Touch-tone temporarily before attempting
phone access).
A Phone Access User’s Guide for phone accessto the securi@ system is
provided with the VoiceModule for the user ofthe system.
Mounting The 4285
Voice Module
The
Voice Module may be mounted in the controlcabinetif spaceis available
or, if this is not possible,on the side of the cabinetor adjacentto it.
When mounting the Module outside the cabinet, use the screw”holes at its
rear which will permit it to be mounted horizontally or vertically (2-faced
adhesive tape may be used, if preferred). Wires can be brought out fkomthe
side or back (a round breakout is also available on the back).
Af6x the VoiceModuIe’s connectionslabel (supplied separately)to the inside
of the Voice Module’s cover if the cover is used. If you have installed the
module within the cabinet,aflix the label to the inside of the controlcabinet’s
door.
-50-
Vista de pagina 49
1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 119 120

Comentarios a estos manuales

Sin comentarios