Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 46)

STOP (STP):

A) 1.

B). 1.

If a “SYSTEM OPERATION’-is chosen (e.g., End of Exit

Time), that operation will cause the device to activate as

selectedin “ACTION.” The different choicesfor “ZONE

TYPE” and “SYSTEM OPERATION” are listed in

“Programming

g Output Relays & Powerline Carrier devices”

later in this section,and in the Progmmming Form.

PARTITION No. (P). The device’s “Start” ZONE

TYPE/SYSTEM OPERATION may be limited to sn occur-

renceon Partition 1, Partition 2, or any partition (A).

The “STOP programming determines when and under

what conditions the device will be de-activated. The

followingoptions are available:

RJE3TORE

ZONE LIST (ZL). If a “ZONE LIST is used

as the “Stop” event, the device will de-activate when all

the zones in that list restore horn a previousfault, trouble,

or al- condition. This will occurregardless of what is

programmed to “START” the device; therefore, a

“RESTORE ZONE LIST’ would normally only be used

when a “ZONE LIST is used to start the device.

ZONE TYPWSYSTEM OPEBATION (ZT). Instead of

using a “RESTORE ZONE LIST, a specificzone (response)

type or system operation action can be selected to de-

activatethe device.

If a specific “ZONE TYPE” is chosen,any zone of that

responsetype that restoresfiwm a previous alarm, trouble,

or fault conditionwill causethe deviceto de-activate.

If a “SYSTEM OPERATION is chosen,that operation will

causethe deviceto de-activate. The ~erent choicesfor

“ZONE TYPE” and “SYSTEM OPERATION are listed in

“Programming Relays & Powerline Carrier devices”later

in this section,and in the Programming

g Form.

PARTITION No. (P). The device’s “Stop” Zone

~e/System Operation maybe limited to an

occurrenceon

Partition 1, Partition 2, or any partition.

46-

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 119 120

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 46