Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 19)

‘1 I

SUPPLEMENTARY

CONTROL

POWERSUPPLY

TERMINALSTRIP

F&ma 7. Using A Su=

)piammtarp

Power Supply For Keypads

check-out Procedura

If you want to checkthat the systemis working beforeconnectingfield wiring

from zonesand devices,do the foll-

Temporarily connecta 2000 ohm end-of-line resistor across each of the

basic hard-wire zones 1-8, as shown in the Summary of Connections

diagram.

Without actual zone wiring or EOL resistors connected,the keypads in

eachpartition ofthe systemwill not display the ‘l?eadfl message.

Power up the system temporarily by plugging the AC transformer

(previouslywired to the control)into a 120VAC outlet.

Busy -

Standby

(Alpha keypads) or dl (Fixed-word keypads) will be

displayed.

-r approximately 1 minute*, the green ‘TtEADY” LED (or TOWER”

LED on some@es of keypads)should light, and the word

READY (Fixed-

word keypads),or DISARMED...READY TO ARM (Alpha keypads) should be

displayed.

* To bypassthe l-minute delay,press# plus O.

If the %eady” display doesnot appesr on any of the keypadsin the system

(in either of the partitions), or a ‘lNotReady messageis displayed, check

the keypad wiring connections,and make sure each of the 8 basic hard-

wired zoneshas a 2000 ohm resistorconnectedacrossits terminals.

When you getthe proper “Ready”displays on the keypad(s),the systemis

functioning properly at this point.

Do not removethe EOL resistorauntil you are ready to make connections

to the hard-wired zones,to allowfor testinglater in the manual.

-19-

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 119 120

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 19