Vista Ademco -10SE Guía para resolver problemas Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 120
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
b. Wire the other three terminals (Sync,- Data, Corn) on the 4300
transformer. Wires from these terminals must be connectedto a 9-pin
connectoron the controlboard (using a 4142TR cablesupplied with the
4300 transformer), as shown in Figure 5. Theseparticular wires canbe
24 gauge or larger, snd can be run along with the AC and ground wires
to the controlpanel.
The complete
wiringfor the 4300 transformer is also coveredin Section 8.
RELAY OUTPUTS & POWERLIAW CARRIER DEVICES.
00 TRANSFORMERANTERFACE
ml
o
Earth
AC
GroundAC i
w
123
Vtt
1252
TERMINALSON
CONTROL
BOARD
n
)
.
~ ‘“””””
000000000 ONm’mo,m)lr?,
1
I
IIIiIiII
1
1
1 t I
I I
1 I
c
4142TRCASLE
1
I
“%-J
H“’” m-r Y
II
NOT
“--
USED
\
USSD
THESEWIRES(7,8,& 9)NOTUSED
UNLESS4145KEW3VITCHANDIOR
Figure 5. Connections of 4300 Transformer To The Control Board
.
IneMhng The Back-Up Battery
If necessary, refer to Section 14. FINAL POWER UP for information
regarding battery sizeto use, etc.
L Place the 12-voltback-up battery in the controlcabinet.
2. Attach Red and Black wires on the batteqyconnectorcableas follows:
a. Red to the positive(+) battery terminal on the control board (see
Summaqy of ConnectionsDiagram for location,ifnecessary)o
b. Black to the negative (-) battery temnind on the control board.
EarthGroundCkmections
The designated earth ground terminal (25), must be terminated in a good
earth ground for the lightning transient protectivedevicesin this product to
be effective. The following are examples of good earth grounds available at
most installations:
Metal Cold Water Pipe: Use a non-comosive metal strap (copper is
recommended) fmly secured to the pipe to which the ground lead is
electricallyconnectedand secured.
AC Power Outlet Ground Available born 3-prong, 120VAC, power outlets
only. To test the integri~ of the ground terminal, use a.three-wire circuit
tester with neon lamp indicators, such as the UL-Listed Ideal Model 61-035,
or equivalent, availableat most electricalsupply stores.
-16-
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 119 120

Comentarios a estos manuales

Sin comentarios