Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 31)

check-out Procedure For Wmd EX@iWSiOQ Zcmes -

After you have completedinstallation of all devices,all expansion zones in

euch ptition of the securitysystemshouldbe checkedas follows:

Make certain that all devices and sensors connected to the wired

expansion zones are not in a faulted state. Doors and windows with

contactsshould be closed,PIRs should be covered (use a cloth to mask

them temporarily if necessary).

With all zones intact (including hard-wired zones), the Alpha keypad

connectedto the systemshould display:

If the followingis displayed,

press the [*] key to display the faulted zone(s). Restore any faulted

zone(s)as necessary(also make sure that you have connecteda 1000 ohm

EOL resistor acrossthe terminals of unused expansion zones on the 4219

or 4229 module).

When the READY TO ARM messageis displayed, you can proceedto the

next step.

Fault and restore every contact or sensor in each expansion zone

individually to ensurethat it is being monitored by the system. Each time

a zoneis faulted, the keypad shoulddisplay the number of the faulted zone

(as programmed by you just previously in *56 mode). When each zone is

restore~ the READY TO ARM messageshould appear again.

If some wired expansion zones have been assigned to partition 1 and

others to partition 2, you will need to observe the keypad in the

appropriate partition as eachzonein that partition is faulted and restored.

When you get the proper displays on the keypad(s), the tied expansion

zonesin the systemare functioningproperly.

Unplug the AC transformer.

+1-

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 119 120

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 31