Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 73)

–73–

10 CONFIRMED

A022-4064 3

When the system sees activity on the appropriate input, it will beep three

times and display the confirmation message. Press [

] or the upper left-

hand button of the program tool to when you are ready to enroll the next

transmitter.

At any time during this step, you may press the [

] key on the keypad or the

upper left-hand button of the program tool if you are satisfied with the serial

and loop number combination that has been enrolled, regardless of whether

or not the enrolled input has been "confirmed." This will ready the system to

enroll the next transmitter.

If the incorrect transmitter has been enrolled, press the [#] key on the

keypad or the upper right-hand button of the program tool to delete the serial

number and return to the "LEARN S/N" prompt. A single long beep will be

heard from the keypad to verify pressing of the upper right-hand button.

Then, press "1" (Yes) or press the upper left-hand button of the program tool

(a single short beep will verify the system is ready for enrolling) and re-

activate the proper transmitter or transmitter loop input.

7. The system will search for the next zone that does not have a serial

number associated with it. If one is found, the prompt in step 5, along

with the appropriate zone number, will be displayed. Follow steps 5 and

6 for the remaining wireless zones.

When the last zone has been enrolled, the display will remain on that zone.

To exit this mode and return to data field program mode, press [*].

When you have finished programming all zones, test each using the system's

TEST mode. Do not use the Transmitter ID Sniffer mode for this, as it will

only check for transmission of one zone on a particular transmitter, and NOT

the zones assigned to each additional loop.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 99 100

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 73