Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 59)

100

–59–

10 INPUT DEV: LP#

RF TRANS. RF: 1

Loop number (LP#): Enter the loop number (1-4) for the zone of the

transmitter being enrolled. The default is loop "1." To accept this, press

[

]. If a different loop number is being used on this transmitter, enter the

desired loop number and press [

] to continue (see the transmitter's

Installation Instructions for specific loop designations). The loop number

must be entered here, whether using Zone Programming or

Sequential Mode to "enroll" transmitters.

10 LEARN S/N?

0 = NO, 1 = YES 0

If the transmitter’s serial number has not been previously “enrolled,” you

may enter the enroll mode now by either entering "1" (YES)

pressing the upper left-hand button of the program tool. If using the

program tool, move to the physical location of the transmitter to be

enrolled before pressing the button. A single short beep will verify that

the button has been pressed. The system will respond to the first serial

number transmitted after the [

] key on the keypad or the button of the

program tool is pressed. Enter "0" (NO) if you wish to enroll the

transmitter later, using the “*83 sequential” mode described in the

SEQUENTIAL MODE

section later in this manual.

If "0" is entered, skip to the summary screen prompt.

10 INPUT S/N: L

A X X X–X X X X

This prompt is displayed if "1" (YES) is entered in response to the "Learn

S/N?" prompt. The serial number may be enrolled by one of two

methods:

a) Enter the 7-digit serial number printed on the transmitter using an

alpha keypad

b) Activate the transmitter by faulting

restoring the input you wish to

use for that zone (e.g., press a button, open or close a door, etc.).

10 INPUT S/N: L

A002-4064 1

The system will enroll the serial number of the first transmitter heard, add

the loop number entered to this serial number, display the serial and loop

numbers, and cause the keypad to beep twice.

If the serial and loop number combination is already present in the system,

a single long beep will be heard from the keypad. If this happens, the

system will not display the serial number, but will wait for a transmission

from another transmitter or transmitter loop input.

The system will then enter an optional confirmation mode so that the

operation of the actual programmed input can be confirmed. Activate the

loop input or button that corresponds to this zone. We recommend that

you confirm the programming of every transmitter before

proceeding to the next zone.

10 CONFIRMED

A022-4064 1

When the system sees activity on the appropriate input, it will beep three

times and display the confirmation message.

At any time during this step, you may press the [

] key on the keypad or the

upper left-hand button of the program tool if you are satisfied with the serial

and loop number combination that has been enrolled, regardless of whether

or not the enrolled input has been "confirmed."

If the incorrect transmitter has been enrolled, press the [#] key on the keypad

or the upper right-hand button of the program tool to delete the serial number

and return to the "LEARN S/N" prompt. A single long beep will be heard from

the keypad to verify pressing of the upper right-hand button. Then, press "1"

(YES) or press the upper left-hand button of the program tool (a single short

beep will verify the system is ready for enrolling) and re-activate the proper

transmitter or transmitter loop input.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 99 100

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 59

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE