Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 11)

–11–

Mounting The Control's Circuit Board Alone in The Cabinet (Fig. 2)

1. Hang two short Black

mounting clips (provided) on the raised cabinet tabs

(see Detail B in Fig. 2).

2. Insert the top of the circuit board into the slots at the top of the cabinet. Make

sure that the board rests on the correct row (see Detail A ).

3. Swing the base of the board into the mounting clips and secure the board to

the cabinet with the accompanying screws (see Detail B in Fig. 2).

Figure 2. Mounting The PC Board

Mounting Control and RF Receiver Circuit Boards Together, in the Cabinet

1. Hang two short (black) mounting clips (provided with receiver) on the raised

cabinet tabs, as shown in Detail B in Figure 3.

2. Insert the top of the receiver board (removed from its own case as described

in its instructions) into the slots at the top of the cabinet, as shown in Detail A

in Figure 3. Make sure that the board rests on the correct row of tabs, as

shown.

3. Swing the base of the board into the mounting clips and secure it to the

cabinet with the accompanying screws (see Detail B in Fig. 3).

4. Insert the top of the control's board into the slot in the clips and position two

long (red) clips at the lower edge of the board (see Detail C).

5. Swing this board into place and secure it with two additional screws.

6. Insert grounding lugs (supplied with the receiver) through the top of the

cabinet into the left-hand terminals of the antenna blocks (at the upper edge

of the receiver board) and secure them to the cabinet top with the screws

provided, as shown in Detail D.

7. Insert the receiver's antennas through the top of the cabinet, into the blocks'

right-hand terminals, and tighten the screws.

8. Refer to the WIRELESS ZONE EXPANSION section for setup and wiring of

the receiver.

Figure 3. Mounting The PC Board And RF Receiver

Together In The Cabinet

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 99 100

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 11