Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 23)

100

–23–

Section 6. WIRELESS EXPANSION

(5800 SYSTEM)

This section provides instructions for installing 5800 series wireless receivers

and transmitters.

General Information

In addition to its basic wired zones, the control supports up to 24 wireless zones

using an appropriate 5881 (5882 in Canada) type RF receiver. The actual

number of zones supported depends on whether you are using a wired zone

expander module.

For example:

If you are using only four of the wired expansion loops, a 5881H

(5882H in Canada) RF Receiver could add 20 RF zones to the system, using any

unused zone numbers 10–31, for a combined total of 24 wired and wireless

expansion zones.

The receiver can detect signals from wireless transmitters within a nominal range

of 200 feet.

RF Receiver No. of Zones

5881L/5882L up to 8

5881M/5882M up to 16

5881H/5882H up to 24

Receiver Supervision

The receiver is supervised, and a trouble report will be generated. CHECK and

zone 09 will also be displayed.

a) If communication between the panel and the receiver is interrupted.

b) If no valid RF signals from at least one supervised wireless transmitter are

received within 12 hours.

House Identification

If you are using a 5804BD, 5827 or 5827BD Wireless Keypad with the system,

you must program a House ID Code (01–31) in field

24 to establish proper

communication, and the keypad must be set to the same ID.

House ID 00 disables all wireless keypads.

Installing the 5881/5882 Receiver

RF System Installation Advisories

Disregard the following advisories if the receiver is mounted in the control

cabinet.

1. Place the RF Receiver in a high, centrally located area for best reception.

2. Do not locate the receiver or transmitters on or near metal objects. This will

decrease range and/or block transmissions.

3. Do not locate the receiver in an area of high RF interference (revealed by

frequent or prolonged lighting of the LED in the receiver. . .random flicker is

OK).

4. The RF receiver must be at least 10 feet from any remote keypads to avoid

interference from the microprocessors in those units.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 99 100

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE