Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 52)

100

–52–

52 TEST REPORT OFFSET 2

0 = 24 hours after exiting program mode or download

1 = 6 hours after exiting program mode or download

2 = 12 hours after exiting program mode or download

3 = 18 hours after exiting program mode or download

This is the time to first report from programming or downloading.

53 SESCOA/RADIONICS SELECT 0

0 = Radionics (0–9, B–F reporting)

1 = SESCOA (0–9 only reporting)

Select 0 for all other formats.

TO PROGRAM SYSTEM

STATUS AND

RESTORE REPORT

CODES

(

59 –

76, &

89)

Report codes can be programmed using the interactive *56 Zone Programming

Mode, or codes can be entered in data fields *59-*76, *89.

The following is a set of guidelines to be used for programming report codes.

The actual report code digits that you enter depend upon the particular

installation, and should be in agreement with you and the central station office

receiving the signals. Use these guidelines to program this entire section.

With a 3+1 or 4+1 Standard Format: Enter a code in the first box: 1–9, A, B, C,

D, E, or F. Enter "#+10" for A (this reports a “0” on some receivers), "#+11" for B,

"#+12" for C, "#+13" for D, "#+14" for E, "#+15" for F.

An entry of "0" in the

first

box will disable a report.

An entry of "0" in the second box will result in automatic advance to the next

field when programming.

With an Expanded or 4+2 Format: Enter codes in

both

boxes (1st and 2nd

digits) for 1–9, or A–F, as described above.

An entry of "0" in the first box will disable a report.

An entry of "0" in the second box will eliminate the expanded message for that

report.

With Ademco Contact ID Reporting: Enter a digit in the first box to enable the

zone to report. Use a different digit for each zone until you have used up

available digits. If the number of zones exceeds the number of available digits,

begin with digit 1 again. This is an "enabling" code only and is not the actual

code sent to the central station office. Entries in the second boxes will be ignored.

For system status (non-alarm) codes, enter a “1” in the first box for all the system

conditions you want to send to the central station.

An entry of "0" in the first box will disable the report.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 99 100

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 52

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE