Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 47)

100

–47–

Section 15. DATA FIELD DESCRIPTIONS

Descriptions of System Data Fields

THE BLANK PROGRAMMING FORM SHOULD BE USED TO RECORD THE DATA FOR THIS INSTALLATION

Defaults (where applicable) Are Indicated In Text

The following pages list all data fields in this control (in numerical order). If you have performed

the programming instructions that were included with the installation of each of the various

peripheral devices covered in previous sections, this table will simply serve as a reference for all

data fields in the system. If you have decided to program all the data fields in the system at one

time (and therefore did not perform the programming indicated previously in each section), you

can use this listing to program all the data fields now.

20 INSTALLER CODE 4 | 1 | 1 | 2

The Installer code is used to enter the 4-digit Master security code for

each partition in the normal operation mode, via the keypad connected

to Partition 1. See "Master Code" in the

SYSTEM OPERATION

section

for procedure.

Enter 4 digits, 0–9.

21 QUICK ARM ENABLE Partition 1 0 Partition 2 0

0 = do not allow quick arm

1 = allow quick arm (the [#] key can be used instead of the security code

when arming the system).

22 RF SYSTEM 0

0 = no RF receiver being used

1 = 5881/5882 RF receiver being used

23 FORCED BYPASS FUNCTION Partition 1 0 Partition 2 0

0 = no forced bypass

1 = provide automatic bypass of all open (faulted) zones

All zones bypassed by this function will be displayed after the bypass is

initiated.

UL installations: must be 0 (no forced bypass)

24 RF HOUSE ID CODE 0 | 0

00 = disable all wireless keypad usage

01-31 = House ID for partition 1

The House ID identifies receivers and wireless keypads.

If a 5827 or 5827BD Wireless keypad or 5804BD transmitter is to be

used, a House ID code MUST be entered, and the keypad should be set

to the same ID.

Partition 2 House ID = partition 1 ID + 1 (use 01–30 for partition 1 if

wireless keypads are used in both partitions).

25 WIRED ZONE EXPANSION 0

0 = no expander module connected

1 = 4219 connected

2 = 4229 connected

3 = 4204 connected

26 CHIME BY ZONE 0

0 = no (chimes on fault of any entry/exit or perimeter zone when chime

mode activated)

1 = yes (chimes on fault of specific zones programmed in relay zone list

3 when chime mode activated)

This option allows the installer to define the specific zones intended to

chime when faulted while the system is in chime mode.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 99 100

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 47

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE