Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 71)

100

–71–

Section 20. USING * 83 SEQUENTIAL MODE

Use

83 Sequential mode when a wireless transmitter is to be physically added, removed, or simply

changed (as when replacing a unit that has a non-removable battery).

By using this mode, you can add, delete, or change the serial number of a transmitter in a zone, but retain

all other existing data that has been programmed for that zone.

Certain button type transmitters have more than one button (e.g., 5801). Note that each button must be

assigned to a different zone. Similarly, the 5816 transmitter has contact terminals

and

a reed switch for

use with a magnet. If using both, each must also be assigned to a different zone.

This means that the procedures that follow must be repeated for each button or contact on the transmitter.

NOTE: Use this mode only after all other zone information has been programmed, including

transmitter loop numbers.

To enroll transmitters sequentially,

after

all other zone information has been programmed, do the

following:

1. Enter Programming mode [Installer Code] + 8 + 0 + 0 on an alpha

keypad. Enter Serial Number Sequential mode by pressing

83. The

following prompt will be displayed.

NOTE: See the

ZONE PROGRAMMING

section for an explanation of the

programming tool.

PROGRAM TOOL?

0 = NO, 1 = YES 0

2. If using a program tool, enter "1." If not using a tool, enter "0." If a tool

has already been programmed, this prompt will not appear. If either not

using a tool or one has already been programmed, skip to step 4.

00 INPUT S/N: L

Axxx-xxxx

3. If "1" is entered, the system will prompt for the unit’s serial number.

Enter the program tool’s serial number using one of the following

methods:

a) Enter the 7-digit serial number printed on the transmitter

b) Press any button on the transmitter. The keypad should beep twice

and display the serial number of the tool.

00 INPUT S/N: L

A123-4567 3

In this example, the serial number is A123-4567. Once enrolled, you can

use the program tool to ready the system for enrolling a transmitter's

serial number by first pressing the upper left-hand button of the program

tool, then activating the desired transmitter (see procedure at the

"LEARN S/N?" prompt.

The serial number for the program tool will only remain in the

system until the programming mode is exited. (Entering *97 will

not delete the tool.)

Press [

] to continue.

Press the [#] key on the keypad to back up to the "PROGRAM TOOL?"

prompt.

ENTER ZN NUM.

(00 = QUIT) 10

Zone Number Entered ↑

4. Enter the first zone number to be enrolled (e.g., zone 10).

Press [

] to continue.

The system will, starting with this zone number, search for the first

transmitter which has

all

of the following attributes pre-programmed in

Zone Programming:

a) An input type of RF, UR, or BR programmed

b) A loop number programmed

c) No serial number programmed

If the first zone number entered does

not

have one or more of the above

attributes, the system will search its database for the first zone that does and

will display it on the next screen.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 99 100

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 71

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE