Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 10)

100

–10–

Section 2. INSTALLING THE CONTROL

This section provides instructions for mounting the control cabinet, and installing

the cabinet lock (if used). Also included in this section are instructions for the

following:

• Installing the main PC board

• Mounting the 5881 (5882 in Canada) RF Receiver board in the cabinet (if

used)

• Standard phone line connections

• Installing the back-up battery in the cabinet

• Connecting the AC transformer

• Making earth ground connections

Mounting the Cabinet

Mount the control cabinet to a sturdy wall using fasteners or anchors (not

supplied), in a clean, dry area which is not readily accessible to the general

public. Four mounting holes are provided at the back of the cabinet.

If an RF Receiver is being used and you intend to mount its PC board within the

cabinet, note the following:

• Do not mount the cabinet on or near metal objects. This will decrease RF

range and/or block RF transmissions from wireless transmitters.

• Do not locate the cabinet in an area of high RF interference (revealed by

frequent or prolonged lighting of the LED in the receiver after it is operational

(random flicker is OK).

Installing the Lock (if used)

Use an Ademco No. N6277 Cam Lock and No. N6277–1 Push-On Clip (Retainer

Clip).

Note: The cabinet can be closed and secured without a lock by using 2 screws

in the cover's edge.

CABINET DOOR BOTTOM

RETAINER

CLIP

RETAINER CLIP

(NOTE POSITION)

RETAINER

SLOTS

LOCKED

UNLOCKED

Figure 1. Installing The Cabinet Lock

1. Remove the cabinet door. It is

easily removable for servicing

and is easily re-installed

2. Remove the lock knockout from

the control cabinet door. Insert

the key into the lock. Position

the lock in the hole making

certain that the latch will make

contact with the latch bracket

when the door is closed.

3. Hold the lock steady, and insert

the retainer clip into the

retainer slots. Position the clip

as illustrated in order to permit

easy removal.

Before installing the cabinet's contents, remove the metal cabinet knock-

outs required for wiring entry. Do not attempt to remove the knockouts

after the circuit board has been installed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 99 100

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 10

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE