Vista Ademco -10SE Guía para resolver problemas descargar pdf (Pagina 57)

100

–57–

Section 16. ZONE PROGRAMMING (*56 Menu Mode)

While in program mode, press *

56 to enter Zone Programming Menu

Mode.

Refer to the zone assignment table for

56 on the separate programming

form .

This is an interactive menu mode that is used to program zone numbers,

zone types, partition numbers, alarm and report codes, and to identify the

type of loop input device. This mode can also be used for "enrolling"

5800 series transmitter ID codes and for entering Alpha descriptors for

zones (we recommend entering descriptors in menu mode

82).

NOTE: If using wireless transmitters, there are two methods for enrolling

the transmitter serial numbers. The first method is by using *56 Zone

Programming mode (described below). The second method is by using

*83 Sequential mode. Note that the *83 Sequential mode requires that all

zone information first be entered using *56 Zone Programming mode.

Program Tool: The Zone Programming and Sequential Modes allow you

to use a 5803 or 5804 button-type transmitter as a "program tool." The

upper left-hand and right-hand buttons of the tool duplicate the [*] and [#]

keypad programming functions. The advantage of using a program tool is

that it enables remote enrollment. You can move to the physical location

of the transmitter to be enrolled, press the upper left-hand button of the

program tool, and then trip the intended transmitter. The transmitter that

you use as the program tool can also be used as a transmitter in the

system. If you plan to use an existing transmitter, it must first be enrolled

into the system as its associated zones. You may then program it as the

tool.

After entering

56, the following prompts are displayed:

If the system has been set up to use wireless transmitters, and a

program tool has been entered, skip to the zone number prompt. If no

program tool has been entered, the following prompt will appear:

PROGRAM TOOL?

0 = NO, 1 = YES 0

If a program tool (5803/5804) is being used, enter "1." If not using a tool,

enter "0" and skip to the zone number prompt.

00 INPUT S/N: L

A X X X–X X X X

If "1" is entered, the system will prompt for the serial number of the

transmitter being used as the program tool. You can enter the serial

number using one of the following methods:

a) Enter the 7-digit serial number for the transmitter

b) Press any button on the transmitter. The keypad should beep twice

and display the serial number of the tool.

00 INPUT S/N: L

A123-4567 3

In this example, the serial number is A123-4567. Once entered, you can

use the 5803/5804 program tool to ready the system for enrolling a

transmitter's serial number by first pressing the upper left-hand button of

the program tool, then activating the desired transmitter (see procedure

at the "LEARN S/N?" prompt).

To back up to the “PROGRAM TOOL ?“ prompt, press the [#] key on the

keypad.

The serial number for the program tool will only remain in the

system until the programming mode is exited. (Entering

97 will not

delete the tool.)

Press [

] to continue.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 99 100

Comentarios a estos manuales

Sin comentarios

Vista Ademco -10SE Guía para resolver problemas Pagina 57

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad Vista Ademco -10SE